patch-2.0.3 linux/drivers/scsi/Config.in

• Lines: 25
• Date: Sat Jul 6 12:06:37 1996
• Orig file: v2.0.2/linux/drivers/scsi/Config.in
• Orig date: Wed Jul 3 22:05:10 1996

diff -u --recursive --new-file v2.0.2/linux/drivers/scsi/Config.in linux/drivers/scsi/Config.in
@@ -44,6 +44,24 @@
     bool '   allow DISCONNECT' CONFIG_SCSI_NCR53C7xx_DISCONNECT
   fi
 fi
+if [ "$CONFIG_PCI" = "y" -a "$CONFIG_SCSI_NCR53C7xx" != "y" ]; then
+  if [ "$CONFIG_SCSI" != "n" -a "$CONFIG_SCSI_NCR53C7xx" = "m" ]; then
+    dep_tristate 'NCR53C8XX SCSI support'  CONFIG_SCSI_NCR53C8XX m
+  else
+    dep_tristate 'NCR53C8XX SCSI support'  CONFIG_SCSI_NCR53C8XX $CONFIG_SCSI
+  fi
+  if [ "$CONFIG_SCSI_NCR53C8XX" != "n" ]; then
+    bool '  enable tagged command queueing' CONFIG_SCSI_NCR53C8XX_TAGGED_QUEUE
+    bool '  force normal IO' CONFIG_SCSI_NCR53C8XX_IOMAPPED
+    bool '  not allow targets to disconnect' CONFIG_SCSI_NCR53C8XX_NO_DISCONNECT
+    bool '  force asynchronous transfer mode' CONFIG_SCSI_NCR53C8XX_FORCE_ASYNCHRONOUS
+    bool '  force synchronous negotiation' CONFIG_SCSI_NCR53C8XX_FORCE_SYNC_NEGO
+  fi
+  if [ "$CONFIG_SCSI_NCR53C8XX" != "n" -a $CONFIG_EXPERIMENTAL = 'y' ]; then
+    bool '  disable master parity checking' CONFIG_SCSI_NCR53C8XX_DISABLE_MPARITY_CHECK
+    bool '  disable scsi parity checking' CONFIG_SCSI_NCR53C8XX_DISABLE_PARITY_CHECK
+  fi
+fi
 dep_tristate 'IOMEGA Parallel Port ZIP drive SCSI support' CONFIG_SCSI_PPA $CONFIG_SCSI
 dep_tristate 'PAS16 SCSI support' CONFIG_SCSI_PAS16 $CONFIG_SCSI
 dep_tristate 'Qlogic FAS SCSI support' CONFIG_SCSI_QLOGIC_FAS $CONFIG_SCSI