crash.shar.gz This program exercises your system to see how crash proof it is. CAUTION!!! Do not use this program unless you are prepared to deal with the results of a crash. It claims to crash any system given enough time. ide_conf.shar.gz There was a message on comp.unix.bsd a while back with a DOS program that determined the real disk parameters on IDE disks. It works on at least some ESDI and probably most other modern controllers as well. It prints the CMOS geometry, asks the drive for its current geometry and prints it, then resets the controller and asks again for the native geometry. It then forces DOS to be rebooted, as the controller is not in synch with the software. lharc-patches.gz Patches for lharc compression utility 0.03 Beta under BSDI. zoo21-patches.gz Patches for zoo 2.1 compression utility under BSDI. top-3.0.tar.gz Program to continually monitor the status of a system, including the top resource consuming programs. top-3.0-bsd386v1.0.gz Patches to the top 3.0 program to allow it to compile and work under BSDI BSD/386 1.0. yum.shar.g Curses based menuing system for BSDI BSD/386, by david@elwapo.agricon.com (David C. Brown) less-177zh.tar.gz Less 1.77 modified to automatically decompress or ungzip files as necessary. Modifications and port to BSD/386 1.0 by Ralf Gebhart (Ralf.Gebhart@E-Technik.TU-Muenchen.de) skill-3.4a.tar.gz Intelligent kill program with prompting. Comes with a pre-compiled binary for BSD/386 1.1 Beta. Modificaitons and port to BSD/386 by Joe Beauchamp jrb@csi.compuserve.com. c-kermit.5a189-bsd3861.1-diff.gz Patches to C-Kermit 5A(189) for compiling and 'Usual' baud rates up to 230 kBit/sec are supported with the termios defines. By Bernhard Schneck (Bernhard.Schneck@Physik.TU-Muenchen.DE). ytalk-3.0p1.tar.gz Port of Ytalk 3.0 PL 1 Multi-User chat program. Has X11 interface as well. Ported by Vladimir Vorobyev and uploaded by Michael Krause nag.1.0.tar.gz NAG, "Not A GUI" but nice none the less, is a simple, but stylish and consistent interface for those situations where a bit mapped GUI is not practical nor possible. The NAG interface features hyper-text linked menus, list manager, easy system call access, hooks to C object modules, and much more. Developed on BSD/386 and ready to run. By Gintaras Richard Gircys . xhfs0_3-bsdi.tgz This is a port of a program which reads Mac format (HFS) 1.4Mb floppies. It doesn't yet write them, but it's still pretty handy. I did not write the package and since I have both my Mac and PC on Ethernet, I have little incentive to do any more work to it. :-) By "Parag Patel" . sendpage5a_BDSI.tar.gz Sendpage pager software package (alpha 5) ported to BDSI 2.0 by reichert@internet.com (Brian Reichert). See sendpage5a_BDSI.README for Brian's steps. ytalk-3.0p2-bsdos20x.tar.gz New version of ytalk modified to compile on BSD/OS 2.x. Changes were trivial: Imakefile had some "# line ..." lines which confused the preprocessor; I replaced them with "# ;line ...". header.h had a conflicting extern declaration of sys_errlist[], so I #if'd if out for __bsdi__. Ported by Jay Vassos-Libove . pwrfaild.tar.gz Version of Jeff Polk's UPS interface modified for use with APC UPS's and uploaded by Walter Poxon . There is also now a man page; thanks again to Walter. scilab-2.2-bin-bsdi.tar.gz scilab-2.2-src-bsdi.tar.gz Scilab is an Xlib based (though it _will_ run in character command-line mode) interactive scientific computation environment. It includes "toolboxes" for 2D and 3D graphics, robust control, linear and non-linear ODE's, signal processing, linear algebra, optimization and ARMAX identification, as well as a graphical event-driven simulation environment. Built-in extensive online help and demos. The binary version: the minimum for running Scilab (without sources) is about 20 Mb when decompressed. The source version: Scilab requires approximately 75Mb of disk storage to unpack and install (all sources included). Uploaded by Marvin P. Kraska . pcomm.2.0.2a.tar.gz A Procomm work-alike that Bruce uses for dialing out over the modem. This version has several of his fixes/enhancements outlined in the file README.BSDI. Uploaded by Bruce Momjian . ss-1.3.3.tar.gz A spreadsheet program that is a basically the 'sc' spreadsheet with a user-interface rewrite for Lotus-style menus. Much easier to use than sc. Uploaded by Bruce Momjian .